FA Parkes 60117 Instruction Manual

Page 1
Digital Electronic Combination Lock
KEYPAD
'Unlocked' indicator light
HOW TO OPERATE
Locking/Unlocking
To Unlock
1. Enter factory default passcode 1234 + OK
2. Long beep will sound.
3. Green indicator light
4. Rotate the knob 90° within 3 seconds to open the lock. If the wrong passcode is entered, a beep will sound 3 times.
5. If lock shows red light
NOTE: When entering Management Passcode to unlock, user passcode will be changed back to default 1234.
To Lock
1. Rotate the knob back to lock position.
SETTINGS
1. Change passcode
1. Enter current User Passcode + OK
displayed.
2. Press OK OK for at least 2 seconds, then
3. Input new passcode, press OK
NOTE: Passcode can consist of 4-15 digits. Management Passcode and User Passcode can not be the same code.
2. Turn on public mode, set temporary password
1. Enter current Management Passcode +OK
displayed
2. Press OK OK for at least 2 seconds, Unlocking indicator light
3. Input "4 4" and press OK
'Low power' indicator light
OK or enter factory default Management Passcode 4321 + OK
will come on
this indicates low battery level.
OK, or Management Passcode + OK
will flash.
OK. When you hear a long beep passcode has been changed.
OK , a long beep will sound and Unlocking indicator light
OK. When you hear a long beep public mode has been set.
Instruction Manual
BATTERY COMPARTMENT
USB KEY INTERFACE
OK . Long beep will sound and
will flash. Press OK OK again.
Part No. 60117
OK.
will be
will be