Advertisement
■ Part Names
◆ PCY130
◆ PCY130S
Rotation Stopper Ribs
Pad
Edge
Pad
Level Adjustment Knob
(Switches are embedded in the edge section on the PCY130S and edge and cup sections on the PCY150S)
■ Setting Up
First setup the rack system (Yamaha RS150, etc.) or a commercially available cymbal stand
(Yamaha CS series, etc.) and then attach the PCY130/130S/150S as shown in the illustration.
Make sure that the pad is securely attached to the rack or stand. If the bolt is not tightened
securely, the pad can slip or fall down causing injury. Also, if the rack or stand is placed on an
unstable surface, etc., the rack or stand can fall over resulting in injury.
NOTE: The PCY130/130S/150S is supplied with
a stopper that allows positioning of the
pad at any angle when used. When using
the stopper, please attach as shown in the
illustration.
1
. First, insert the stopper underneath the
cymbal support, and then use a drum key
(optional) to secure.
2
. Set the PCY130/130S/150S so that the
rotation stopper plate fits between the ro-
tation stopper ribs located on the under-
side of the PCY130/130S/150S.
* The PCY130/130S/150s is supplied with thin
felts. Pad vibration can be adjusted by using these
felts in place of those that came with the rack
system or cymbal stand.
■ Troubleshooting
If the following trouble occurs when the PCY130/130S/150S is used, please check the
following points before asking your dealer for assistance.
● No Sound, Volume is Low
Problem
Is the PCY130/130S/150S properly
Refer to the previous [Connections] section and make sure
connected to the DTX Series Drum
that all connections are proper.
Trigger Module with the supplied ste-
reo phone cable? (A monaural phone
cable can be used with the PCY130.)
Is the Level Adjustment Screw on
If the Level Adjustment Screw is set too low, the single pro-
the PCY130/130S/150S set too
duced by the pad will be too low to produce sufficient volume
low?
from the drum trigger module's tone generator even though
the pad is struck.
Is the module properly con-
Check the connections between the external device and the
nected to a pair of headphones
position of the power switch and volume level.
or an external audio device such
as an amplifier, speaker, etc.?
Are module settings correct?
Check the volume setting of the voice assigned to the INPUT
number to which the PCY130/130S/150S is connected (refer
to the previous "Adjusting the Voice Volume" section), or make
sure the headphones volume level is not set too low, etc.
● Hitting the pad once produces multiple sounds (Double trigger)
Problem
Is the level adjustment on the
Too high of a the level adjustment setting causes the drum
PCY130/130S/150S set too high?
module to produce multiple sounds because the large signal
produced by the high settings sustains for too long of a time.
Refer to the "Output Level Adjustment" section described
above to properly set the pad's output level.
● The edge or cup sections do not produce sound when struck. The Mute or
Choke functions do not work.
Problem
Is the PCY130S/150S connected
Refer to the "Connections" section described above and
to the correct INPUT number on
make sure the PCY130S/150S is connected to the correct
the DTX Series Drum Trigger
INPUT number.
Module using the supplied ste-
When a monaural phone cable is used, the voices assigned
reo phone cable?
to the edge and cup sections are not produced.
Since the PCY130 is not equipped with a edge switch, switch
functions cannot be used (refer to the "Connections" sec-
tion).
Are module settings correct?
Refer to the section on trigger settings in the Owner's Manual
that came with your module and make sure settings are cor-
rect.
◆ PCY150S
Rotation Stopper Ribs
Cup
Edge
Output Jack
Pad
Level Adjustment Knob
Wing Nut
Cymbal Support
Stopper
Rotation Stopper Ribs
What to check
What to check
What to check
■ Connections
Using the supplied stereo phone cable, connect the output jack on the PCY130/130S/
150S to the input jack on the DTX Series drum Trigger Module (DTXTREME/DTX/
DTXPRESS). Insert the L-shaped connector into the output jack on the PCY130/130S/
150S.
Output Jack
Function of the PCY130/130S/150S varies according to which INPUT number on the
DTX Series Drum Trigger Module the pad is connected. The chart below describes its
function in relation to input numbers.
* Make sure you set the module's pad type setting to cymbal. (Refer to the Owner's Manual that came
with your module.)
Module
Input Number PCY130 PCY130S PCY150S
DTXTREME s 1〜8
9/10〜15/16
DTXPRESS
1
DTXPRESS
2,6,7
*
Felt
3〜5,8
9/10
DTXTREME
1〜5
6〜8
9/10〜15/16
DTXPRESS
1
2〜8
9/10
DTX
1〜8
9/10,11/12
* Make sure a stereo phone cable is used when connecting the PCY130S/150S to the module. The
switch functions described above will not function with a monaural phone cable. (Only the voice
assigned to the pad can be produced.)
Since the PCY130 does not incorporate a edge switch, use of a monaural phone cable is allowed.
Also, please refer to the Owner's Manual that came with your DTX Series Drum Trigger Module
(DTXTREME/DTX/DTXPRESS) for more information regarding the problems described above and any
other problems that you may be experiencing.
If a solution can not be found to the problem after consulting the manuals, please contact the dealer from
whom you purchased the product.
■ Specifications
● PCY130 Cymbal Pad (13")
Size
Weight
Sensor System
Output Jack
● PCY150S Cymbal Pad (15")
Size
Weight
Sensor System
Output Jack
* Improvements may result in a change in the specifications and/or design of the product without notice.
NOTICE: Service charges incurred due to a lack of knowledge relathing to how a function or effect works (when the unit is operating as
designed) are not covered by the manufacturer's warranty, and are therefore the owners responsibility. Please study this manual
carefuly and consult your dealer before requesting service.
ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. We sincerely
believe that our products and the production methods used to produce them, meet these goals. In keeping with both the letter and the
spirit of the law, we want you to be aware of the following:
Warning: Do not attempt to disassemble.
Disposal Notice: Should this product become damaged beyond repair, or for some reason its useful life is considered to be at an end,
please observe all local, state, and federal regulations that relate to the disposal of products that contain lead, plastics, etc. If your
dealer is unable to assist you, please contact Yamaha directly.
NAME PLATE LOCATIOIN: The name plate is located on the bottom of the product. The model number, serial number are located on
this plate.
You should record the model number, serial number, and the date of purchase in the spaces provided below and retain this manual as
a permanent record of your purchase.
Model : PCY130
Model : PCY150S
Purchase Date
Output Jack
Insert
●：A single voice can be assigned to, and produced
by the pad.
●
○*
◎*
○：Independent voices can be assigned to and pro-
duced by the pad and edge section (Dual Zone;
●
●
●
The cup and pad sections share the same voice).
A choke function (grabbing the edge section stops
●
○
△
the voice being produced by the pad) is also avail-
able.
●
○
◎
□：Independent voices can be assigned to and pro-
●
○
□
duced by the pad section, and the edge/cup sec-
tions (Dual Zone; The edge and cup sections
●
●
●
share the same voice).
A choke function (grabbing the edge section stops
●
○*
△*
the voice being produced by the pad) is also avail-
able.
●
○*
□*
◎：Independent voices can be assigned to and pro-
●
●
●
duced by the pad section, edge switch, and cup
section (3 Zone).
●
○
△
A choke function (grabbing the edge stops the
voice being produced by the pad) is also avail-
●
○
□
able.
△：Independent voices can be assigned to and pro-
●
●
●
duced by the pad and cup section (Dual Zone;
the edge switch is inactive).
●
○*
□*
* ： A mute function (holding the edge section pro-
●
●
●
duces an alternate sound when the pad is hit) is
also available.
● PCY130S Cymbal Pad (13")
ø329 X 68(H) mm
1.4kg
Trigger Sensor (Piezo) x 1
Trigger Sensor (Piezo) x 1 / Edge Switch x 1
Standard Monaural Phone Jack
Standard Stereo Phone Jack
ø386 X 70(H) mm
1.8kg
Trigger Sensor (Piezo) x 1 / Switch x 2 (Edge, Cup)
Standard Stereo Phone Jack
SPECIAL MESSAGE SECTION
Serial No.
Model : PCY130S
Serial No.
PLEASE KEEP THIS MANUAL
Serial No.
Printed in Indonesia
WF75960
Advertisement
