Cisco SFS 3504 Installation And Configuration Note page 7

Slide the Cisco SFS 3504 Server Switch between the rack posts (see
Step 3
on the front of the chassis make contact with the front rack posts.
Use four customer-supplied fasteners (two for each side) and the appropriate screwdriver (not included
in the accessory kit) to firmly secure the rack ear brackets to the front rack posts.
Note
Figure 2 Sliding the Cisco SFS 3504 Server Switch Between Rack Posts and Inserting Brackets
SF S3 50
0
Se rie s
INP UT
FAN
OK OUT PUT
OK
FAI L
ALL FAS
TEN ERS
FUL LY ENG
MU ST BE
OPE RAT AGE D PRI
ION OF OR TO
POW ER
SUP PLY
100 -240
V
! 8-4A
CAU TIO 50/6 0Hz
N: DIS CON
NEC T POW
ER BEF
ORE SER
VIC ING
Slide the two adjustable brackets, from the back, between each of the guide rails that are attached on
Step 4
either side of the Cisco SFS 3504 Server Switch at the data connection end. (See
Adjust the adjustable brackets so that the holes in the brackets align with the holes in the rack posts, and
Step 5
secure the brackets to the rack posts. (See
Use four standard rack screws (two for each bracket; rack screws not included in the accessory kit) to
secure the adjustable brackets to the rear rack posts.
78-18335-01
The handle on the AC power-fan module and/or the blanking panel can be used as an aid to
support the power-fan module side of the chassis during rack-mounting installation.
SF S3 50
0
Se rie s
INP UT
FAN
OK OUT PUT
OK
FAI L
ALL FAS
TEN ERS
FUL LY ENG
MU ST BE
OPE RAT AGE D PRI
ION OF OR TO
POW ER
SUP PLY
100 -240
V
! 8-4A
CAU TIO 50/6 0Hz
N: DIS CON
NEC T POW
ER BEF
ORE SER
VIC ING
Cisco SFS 3504 Multifabric Server Switch Installation and Configuration Note
Installing the Cisco SFS 3504 Server Switch
Figure
Figure 2.)
2), until the rack ear brackets
Figure 2.)
7