Table of Contents
Advertisement
HEADLIGHT BEAM ADJUSTMENT
ELECTRICAL
HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine from the wall at a dis-
3. Measure the distance from the floor to the
4. With a person sitting on the machine, apply
5. Turn the headlight to high beam and check
6. Adjust:
8
tance
indicated by the chart below.
center of the headlight
on the wall equal to distance
floor.
the parking brake, start the engine and let it
idle.
the headlight projection height on the wall.
The projection should be at the parallel
mark on the wall
to 1/2° down
the mark. If not, adjust the headlight angle.
3.0 m (10 ft)
26 mm (1.0 in)
: Distance
: Height
• Headlight beam (vertically)
Vertical adjustment
Higher Turn the adjusting screw
counter clockwise.
Lower Turn the adjusting screw
clockwise.
INSP
ADJ
and place a mark
from the
from
7.6 m (25 ft)
66 mm (2.6 in)
: Set range
Advertisement
Table of Contents
