Checking Terminals - Pioneer X-HM81-K Service Manual

5

5.4 CHECKING TERMINALS

1. Checking the LAN terminal
Connect the PC and this unit directly then set them up as indicated below. Then, access this unit from the PC via a Web
browser. If the indications shown in the figure below are displayed, the LAN terminal is normal.
If the LAN terminal is not normal, check the circuit between the LAN terminal and CR870 (Module on BCO Assy).
Setup on this unit:
1 Turn the unit on.
2 Select the NETWORK function then press SETUP.
3 Select Network Setup > Connection Setup > Wired >
DHCP OFF.
4 Set the following items as shown below:
IP address: 192.168.0.1
Subnet mask:255.255.255.0
Gateway address: 0.0.0.0
DNS (1st): 0.0.0.0
DNS (2nd): 0.0.0.0
Proxy setting: Not to be used
5 After setting is finished, reboot the unit.
5
6
MAC Address seal
X-HM81-K
6
7
Setup on the PC:
1 Click on Start > Settings > Control Panel.
2 Open Network Connections then Local Area Connection
by double-clicking on its icon.
3 Click on Properties to open the Properties window for
the local area connection.
4 Double-click on Internet Protocol.
5 Set the items as shown below.
7
8
A
B
C
D
E
F
25
8