NETGEAR AGM731F Installation Manual

Installation Guide
SFP 1G Fiber Module
AGM731F and AGM732F
The 1000Base-X SFP transceiver module provides full-duplex 1000Mbps Ethernet
operation in each direction for NETGEAR managed switches.
The switch automatically detects the module, so you can simply plug it into an available
module slot.
WARNING: Because invisible laser radiation might be emitted from the aperture
of the port when no fiber cable is connected, avoid exposure to laser radiation and
do not stare into open apertures.
Install the module
1. Insert the module into a slot that supports the SFP interface.
You will hear a click sound when the module is firmly seated.
2. Lift the latch on the module to lock it in place.
Remove the module
1. Lower the latch on the module to unlock it.
2. Grasp the sides of the module and pull it straight forward out of the slot.
Technical Specifications
Standards AGM731F: IEEE 802.3z, 1000Base-SX
AGM732F: IEEE 802.3z, 1000Base-LX
Connectors AGM731F: LC for 62.5/125µm or 50/125µm cable
AGM732F: LC for 9/125µm cable
Dimensions (H x W x D) AGM731F: 2.23 x 0.53 x 0.34 in (56.8 x 13.6 x 8.6 mm)
AGM732F: 2.26 x 0.53 x 0.33 in (57.4 x 13.4 x 8.5 mm)
Weight AGM731F: 0.58 oz (16.3 g)
AGM732F: 0.56 oz (16.0 g)
Storage temperature –40–185ºF (–40–85ºC)
Case operating 23–158ºF (–5–70ºC)
temperature
Operative relative 85% at 77ºF (25ºC)
humidity
Operating distance AGM731F:
multi-mode fiber (MMF)
OM1: 900 ft (275 m)
OM2: 900–1,800 ft (275–550 m)
OM3: 1,800 ft (550 m)
Operating distance AGM732F: 6 mi (10 km)
single mode fiber (SMF)
Power consumption 1.1W
MTBF AGM731F: >10 years
AGM732F: >10 years
Safety certification UL 60950-1, CSA-C22.2 No.60950-1
Environmental RoHS
compliance