Cisco 2654T6 Repacking Manual page 17

Appendix A Repackaging the Router
To reinstall the router and scissor-jack platform on the shipping pallet, use
Figure A-7
Use the hand truck to move the chassis to a level, open space with a solid floor.
Step 1
Tilt the chassis upright so that it stands on the scissor-jack platform, then remove
Step 2
the hand truck.
Use the bolts from the original shipping package to attach the eight hold-down
Step 3
brackets to the sides of the scissor-jack platform (two brackets on each side).
Note
Position the U-shaped pallet body behind the scissor-jack platform with the
Step 4
opening facing the back panel of the router.
Use the 3/4-inch (19-mm) socket and ratchet wrench to turn the scissor-jack screw
Step 5
slowly counterclockwise to expand the scissor-jack platform and raise the top of
the scissor-jack platform high enough for the hold-down brackets to clear the top
of the pallet body.
Slide the pallet body around the scissor-jack platform.
Step 6
Slide the pallet front bar into the opening on the pallet body and use the hinge
Step 7
locks to secure it as instructed in these steps:
a.
b.
c.
d.
e.
OL-17440-01
as a reference and follow these steps:
The hold-down brackets are not symmetrical: The bracket plate that
fastens to the side of the scissor-jack platform is narrower than the bracket
plate that fastens to the top of the pallet, and has smaller diameter bolt
holes.
Pivot the butterfly handle on the hinge lock up so that it is perpendicular to
the body of the hinge lock.
Twist the butterfly handle counterclockwise to extend the hinge lock hook to
its maximum reach.
Lower the hinge lock hook over the hinge lock catch on the pallet body.
Twist the butterfly handle clockwise to clamp the hinge lock hook on the
hinge lock catch on the pallet body.
Pivot the butterfly lever down onto the hinge lock body so that it lies flat.
Cisco XR 12416 and Cisco XR 12816 Router Chassis Installation Guide
Repackaging the Routers
A-17