6.4 Assembling the right-hand brake
trigger
(545 TrioBrake, 550 XP TrioBrake,
550 XPG TrioBrake)
1
Reattach the right-hand brake trigger in its mount
on the rear handle and tighten screw
the brake cable in its track and tighten screws
See figure 5 and 4.
2
Replace the cover and tighten screw F. Replace
the movement limiter E.
3
Fit the front handle and tighten screws . Tighte-
ning torque 3-4 m.
Fit the
•
The bar
•
The chain
•
The clutch cover
6.5 Dismantling the muffler
WARNING!
Do not touch the muffler until it
has cooled. Risk of burns.
1
Remove the cylinder cover, muffler, gasket and
cooling fin.
2
The saw is fitted with spark arrestor mesh, which is
removed. If necessary, use the combination span-
ner to push down the plate edge and remove the
spark arrestor mesh. See figure 12.
Cleaning and inspection
•
Clean and check all components carefully.Parts
must be replaced if cracked or show signs of
other defects. Always use original spare parts.
• The spark arrestor mesh is best cleaned with a
wire brush.
• The mesh must be replaced, if damaged. The
saw will overheat if the mesh is clogged resul-
ting in damage to the cylinder and piston.
• ever use a saw with a clogged or defective
muffler.
. Reposition
Fig 1
Safety equipment
21
English -