Disassembling The Antihopping Clutch - Husqvarna FS 450 2017 Repair Manual

17.4.36

Disassembling the antihopping clutch

-
Mount and tighten screws
Guideline
Screw, rocker arm
bearing
-
Mount and tighten screw plugs
Guideline
Screw plug, rocker
arm shaft
-
Clamp clutch
• Info
I
Use soft jaws.
-
Carefully loosen special tool
-
Take the clutch out of the vise and place it on a clean work­
bench with the outside inner clutch hub (D facing down­
ward.
-
Take the inside inner clutch hub
out of the outer inner clutch hub.
306628-10
-
Remove clutch facing discs (D from the outer inner clutch
hub.
-
Remove sleeves @.
-
Clean all parts well.
-
Check the clutch.
306629-10
@.
15 Nm (11.1 lbf ft)
M7
@)
with the O-ring.
M10x1 .25
10 Nm (7.4 lbf ft)
O
into a vise.
8
in steps and remove it.
C,
and release springs
(0 p. 213)
ENGINE 17
41
0
41
211