Assembly And Adjustments; Operation; Installing And Removing The Battery Pack - Craftsman CMCV002B Instruction Manual

It is recommended that the tank be emptied of any dry
contents prior to being used for wet pick up to facilitate
tank cleaning.
This product is NOT to be used for filtering of pathogens,
for example Covid-19. Follow all local, state, and federal
guidance on general cleaning practices.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Attaching Vacuum Hose (Fig. A, B)
The vacuum hose will need to be attached to the
8
vacuum before using the appliance.
1. Place the vacuum on a flat, firm surface.
2. Unlatch tank latches
the tank. Remove the vacuum hose
3. Align the hose end 13
front of the appliance, ensuring the hose alignment lock
14 is aligned with the arrow
4. Insert the hose end into the intake port and twist
clockwise to lock in place.
5. Replace power head onto the tank and secure latches.
nOTE: The power head will only fit onto the tank when the
intake port on the front of the power head and the storage
area for the wide nozzle tool
Fig. B
14 15
13
To reduce the risk of
and remove power head from
5
from the tank
8
with the intake port 6
15 on the intake port.
on the tank are aligned.
12

OPERATION


WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental can
cause injury.

Installing and Removing the Battery Pack

(Fig. C)

CAUTION:
terminals are dry and clean before installing
battery pack.
To install the battery pack
the battery pack with the rails inside the tool's battery port
7 until the battery pack is firmly seated in the tool and
ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
17
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. C
.
4
17
on the
16
7
Using the Vacuum
On / Off Switch (Fig. A, D)
1. Attach the appropriate accessory to the vacuum hose
2. Insert battery pack.
3. To turn vacuum on, press the I/O (on/off) button
To reduce the risk of
Ensure battery port and
16 into the power head, align
and firmly pull the battery pack out of the tool
English
.
8
.
1
7