Cisco Card Cage and Backplane 7513-MX Replacement Instructions Manual page 19

Figure 14 Replacing the Card Cage and Backplane Assembly
Captive screw
Card cage
side flange
Captive screw
Air intake grill
POW ER
A
Caution The electronic components on the rear of the backplane are completely exposed when the
card cage and backplane assembly is removed from the chassis. To prevent damaging these
components, carefully slide the assembly into the chassis opening. (See Figure 14.)
Step 3 Replace the processor modules in the card cage. To do so, see to the "Replacing Processor
Modules" section on page 11.
This completes the procedure for replacing the card cage and backplane assembly in the Cisco 7513,
Cisco 7513-MX, and Cisco 7576. Proceed to the next section "Replacing Power Supplies."
Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card Cage and Backplane Assembly Replacement Instructions
Installing the New Card Cage and Backplane Assembly
Captive screw
Card cage
side flange
Captive screw
POW ER
B
19