Figure C
2
Removing the Hand-Held Steam Cleaner
(Fig. D)
•
Push the release button
9
steam cleaner
2
away from the steam mop body
Figure D
2
Attaching a Cleaning Pad (Fig. A, E)
Replacement cleaning pads are available from your
BLACK+DECKER dealer (cat. no. SMP20).
•
Place a micro-fiber cleaning pad
the 'hook & loop' side facing up.
•
Press steam mop down onto the cleaning pad. You are
now ready to steam clean and sanitize your floor.
NOTICE: Do not store with a wet pad as this can
damage your floor. Always place the steam mop
with the handle tube
6
stationary and make sure the steam mop is turned off
and unplugged when not in use.
Figure E
21
Removing a Cleaning Pad (Fig. E)
CAUTION: Always wear suitable shoes when
changing the cleaning pad on your steam mop. Do
not wear slippers or open-toed footwear.
1. Return the handle tube
6
turn the steam mop 'OFF'.
2. Wait until it cools down. (approximately five minutes)
3. Place the front of your shoe onto the cleaning pad
removal tab
29
and press down firmly.
4. Lift the steam mop up off the cleaning pad.
10
down and pull the hand-held
10
.
9
10
21
on the floor with
in the upright position when
29
to the upright position and
NOTICE: Do not store with a wet pad as this can
damage your floor. Always place the steam mop
with the handle tube
stationary and make sure the steam mop is turned off
and unplugged when not in use.
Hand-held Steam Cleaner Attachments
NOTICE: Remove the hand-held steam cleaner from
the steam body after turning off and unplugging the
steam mop, and after allowing the steam mop to
cool down.
Attaching the Hose and Steam Glove
(Fig. F)
1. Firmly press the hose (
11
nozzle of the hand-held steam cleaner such that it is
fully seated.
2. To remove, depress the hose release button
pull the hose out of the hand-held steam cleaner.
WARNING: Inspect the seal
steam cleaner
2
and the seal
hose before each use (Figure F). If the seal is missing
or damaged contact your nearest authorized repair
agent. Do not use the appliance.
CAUTION: Ensure that the hose is securely fastened
before using the hand-held steam cleaner.
Figure F
32
11
30
Attaching Other Accessories to the Hose
(Fig. G)
1. For other accessories other than the steam nozzle, align the
lugs
on the hose with the recesses on the accessory.
33
2. Press the accessory onto the hose and twist clockwise until
the accessory is fully seated and clicks into place.
Figure G
Attaching Steam Jet Nozzle (Fig. H)
1. Press in the clips
34
on the steam jet nozzle
2. Align the two keys on the inside flange of the steam jet
nozzle with the two slots at the end of the hose
3. Firmly press the steam jet nozzle onto the hose such that
it is fully seated, and release the clips.
English
6
in the upright position when
or
14
) onto the steam
, and
30
31
on the handheld
32
at the end of the
31
33
24
.
.
11
5