1-2-3. Output PC Board
1. Eject the tray slightly.
2. Peel off the tape (1).
3. Remove the connector (2) and the flexible cable (3).
4. Remove two screws (4), then remove the output-RGB
PC board (5).
Note:
• Wind the wire around the connector (6) several times
when mounting the connector (2).
Connector (2)
Wind the wire
several times.
Connector (6)
Connector (2)
Connector (6)
Eject the tray slightly.
Fig. 2-1-9
Tape (1)
Output RGB PC board (5)
Screws (4)
Tray
1-2-4. Front PC Board (SD-220)
1. Remove the front panel. (Refer to item 1-1-3.)
2. Remove eight screws (1), then remove the front
display PC board (2).
3. Remove the flexible cable (3).
4. Remove three screws (4), then remove the ENTER
switch (5).
ENTER
Switch(5)
Flexible
cable (3)
1-2-5. Front PC Board (SD-120)
1. Remove the front panel. (Refer to item 1-1-3.)
2. Remove eight screws (1), then remove the front
display PC board (2).
Screws (4)
Front display
PC board (2)
Screws (1)
Flexible
cable (3)
Fig. 2-1-10
Front display
PC board (2)
Screws (1)
Fig. 2-1-11