Cisco PA-FE-FX Installation And Configuration Manual page 32

Removing a Port Adapter
Figure 4-1
Figure 4-2 shows a Cisco 7206 with a PA-FE-FX installed in slot 4.
Figure 4-2
Note
connector in place of the RJ-45 connector.
Removing a Port Adapter
Use the following procedure to remove a port adapter from a Cisco 7200 series router:
Step 1
Warning
not directly touch the backplane with your hand or any metal tool, or you could shock yourself.
Step 2
4-2 PA-FE-TX and PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
Cisco 7206 with a PA-FE-TX in Slot 4
Cisco 7206 with an PA-FE-FX in Slot 4
The PA-FE-FX has the MII connector like the PA-FE-TX, but has an SC-type fiber-optic
Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do
Place the port adapter lever for the desired port adapter slot in the unlocked position. The
lever remains in the unlocked position. (See Figure 4-3.)
PA-FE-TX port adapter
ETHERNET 10BT
FAST ETHERNET INPUT/OUTPUT CONTROLLER
PA-FE-FX port adapter
ETHERNET 10BT
FAST ETHERNET INPUT/OUTPUT CONTROLLER
TOKEN RING
ETHERNET-10BFL
TOKEN RING
FAST ETHERNET
ETHERNET-10BFL