Cisco PA-2E3 Installation And Configuration Manual page 60

Checking the Configuration
For Cisco 7100, Cisco 7200, and Cisco uBR7200 series routers, use the show controllers serial
command, using arguments such as the slot and port number (slot/port), to display information that
is specific to the serial interface hardware. Following is an example of the show controllers serial
slot/port command that shows the serial port adapter installed on a Cisco 7200 series router in
chassis slot 3:
router# show controllers serial 3/0
M1T-Serial: show controller:
PAS unit 0, subunit 0, f/w version 1-23, rev ID 0x1, version 2
idb = 0x608E3340, ds = 0x608E50C0, ssb=0x608E5A84
Clock mux=0x35, ucmd_ctrl=0x8, port_status=0x25
maxdgram=4474, bufpool=64Kb, 128 particles
line state: up
Serial DTE cable
(Display text omitted.)
For a VIP2, use the show controllers serial command, using arguments such as those that specify
the slot, port adapter, and port numbers (slot/port-adapter/port), to display information that is
specific to the serial interface hardware. Following is an example of the show controllers serial
slot/port adapter/interface command that shows serial port 2/0/1 on a one-port PA-E3 installed on a
VIP2 in chassis slot 1:
router# show controllers serial 2/0/1
Serial2/0/1
Data in current interval (421 seconds elapsed):
(Display text omitted.)
8-14 PA-E3 Serial Port Adapter Installation and Configuration
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
4084 packets output, 1298712 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
TM=down CA=up LC=down
Mx E3(2) HW Revision 0x2, FW Revision 2.42
Framing is g751, Clock Source is Line, Bandwidth limit is 34010.
National Bit is 0, International Bits are: 0 0
DSU mode 0
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation
0 P-bit Err Secs, 0 P-bit Severely Err Secs
0 Severely Err Framing Secs, 0 Unavailable Secs
0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Total Data (last 1 15 minute intervals):
4 Line Code Violations, 0 P-bit Coding Violation,
0 C-bit Coding Violation,
0 P-bit Err Secs, 0 P-bit Severely Err Secs,
0 Severely Err Framing Secs, 0 Unavailable Secs,
3 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
No alarms detected.