Troubleshooting Wireless Print Servers; Unable To Communicate During Initial Setup - HP jetdirect 175x Administrator's Manual

Troubleshooting Wireless Print
Servers

Unable to Communicate During Initial Setup

Verify the following:
G
Your wireless computer is configured to match the default
wireless network settings on the HP Jetdirect print server:
Communication Mode: Ad Hoc
I
Network Name (SSID): hpsetup
I
Encryption (WEP): <Disabled>
I
Note
G The HP Jetdirect print server is turned on and operating properly
(print a Jetdirect configuration page).
G You are within range of the HP Jetdirect print server.
G
There are fewer than six devices total on the Ad Hoc network
(with SSID "hpsetup").
G
There is no Access Point in the vicinity that is configured with
an SSID of "hpsetup".
G Multiple print servers are not being configured at the same time.
If there are multiple print servers, turn all off except the one you
want to configure.
ENWW
The Network Name (SSID) is case-sensitive. Be
sure to specify "hpsetup" using lowercase
characters.
Troubleshooting the HP Jetdirect Print Server 199