Setup & Operation / Test Digital Lock / Program Anew Passcode - Honeywell 6213DG User Manual

SETUP AND OPERATION
STEP 1. INSTALL BATTERY
1. Open battery compartment. Using fingernail remove sliding battery compartment
. Requires Lithium battery CR2032 (Not Included)
(Figure 1)
2. Insert the battery negative side facing out
3. Re-insert battery compartment. Both the unlock and battery indicators
will flash
(Figure 3)
Figure 1
TEST DIGITAL LOCK
1. With lid open, turn knob left to put locking lid latch in lock position
NEVER STORE KEYS INSIDE CASH BOX!
2. Enter the preset pass code:
3. Turn knob to right within 2 seconds
4. Lock should recede into the unlocked position.
Figure 1
PROGRAM A NEW PASSCODE
1. Input current access code
"1"-"2"-"3"-"4" + OK tone will sound a long beep
and a green unlock indicator light will
flash quickly and then stay lit
2. While the unlock button is lit quickly press
the OK button and hold it for at least 2 seconds,
the unlock indicator light will flash.
3. Input your desired access code, press OK, when
you hear a long beep sound the access code
is set.
NOTE: Password can be 1-15 digits.
.
Figure 2
"1"-"2"-"3"-"4"
Figure 2
(Figure 1)
.
(Figure 2)
Figure 3
+ OK
(Figure 2)
.
(Figure 3)
Figure 3
.
4
(Figure
.
Figure 1
Warning: There is no
reset button please write
down your code.
1).