Related Manuals for Radal Technology Cig-Arrete
Summary of Contents for Radal Technology Cig-Arrete
- Page 1 Anti-Smoking Alarm INSTALLATION GUIDE A New Concept in High Sensitivity Smoke Detection at an Affordable Cost...
- Page 2 Arrete Smoke Alarm System. 1. In order to open the Cig-arrete Main Controller, (part no. CSA-S5B) use a screwdriver The number of cores to depress the plastic locking pins on each side of the controller box as shown in the diagram above.
- Page 3 INSTALLATION GUIDE Anti-Smoking Alarm 7. Connect the cables from the controller back-plate printed circuit board as shown above. If you are not installing the maximum five detectors to your system, remember to include shorting links between Terminal 'C' and whichever inputs (DI to D5) that you are not using.
- Page 4 Each Cig-Arrete Smoke Detector is fitted with an integral red LED lamp, visible once the detector has been installed. Immediately after power up, the LED on each of the detectors will flash for a period of two minutes.This indicates that the detector is...
- Page 5 Anti-Smoking Alarm Anti-Tamper Screwdriver Each of the Cig-Arrete Smoke Detectors can be fixed securely in position within its individual base.This is achieved by means of tightening the Allen screw shown in the diagram using the Anti tamper screwdriver (part number CSA-ATS) to turn the screw six full turns clockwise, or until the detector is locked firmly in its base.This will prevent...