Download Print this page
RadioMaster TX16S Manual

RadioMaster TX16S Manual

Omp m1/m2 rtf configuration
Hide thumbs Also See for TX16S:

Advertisement

Quick Links

OriginHobbies_OMP_M1_M2_TX16S_RTF_OMP_v1.1
OMP M1/M2 TX16S RTF configuration
Thank you for choosing OriginHobbies as your dealer for OMPHobby and Radiomaster products.
We have carefully prepared the RTF model configuration for you so you can start flying your
helicopter as easily as possible. We still recommend that you carefully read this guide so that you
are confident to make your first flight. If you have any questions please do not hesitate to contact
us. Best wishes!
Batteries (setup and care):
Your TX16S Radio Transmitter is delivered with the LiPo battery unplugged for safety during
transportation. Open the battery case and connect the LiPo battery to the Radio Transmitter. Close
the battery case. Please fully charge the Radio Transmitter before first use.
The TX16S Radio Transmitter has 2 USB ports.
The USB port at the top is a data port for connecting to computer. (Simulator mode [HID] or
Data transfer mode [Mass storage])
The USB port at the bottom (under a pull up strip) is a charging port for charging the Radio
Transmitter battery.
For faster charging you can also charge the battery using an external balance charger. Please
disconnect the battery from Radio transmitter before connecting to an external charger.
Battery care tips:
The Helicopter LiPo batteries are shipped at storage charge (50%). Please fully charge the
helicopter battery before any flight. It is recommended to use a balance charger at 1C (max
2C if in a hurry).
Avoid quick charge programs. They will cause the cells to go out of balance with time.
Don't leave battery charging process unattended. There is always risk of heating and fire so
you must be present nearby to take proper action if that happens.
Always use a flight timer depending on your flying style and ensure that battery is never
discharged less than 25% capacity. (about 3.73V per cell)
When not in use for prolonged periods, charge all LiPo batteries to storage charge (50%
charge 3.86V per cell).
Following these simple rules will ensure your batteries are in good health and you can have
many flights with them.
Page 1/3
[OMP Protocol]
© 2021 OriginHobbies.com

Advertisement

loading

Summary of Contents for RadioMaster TX16S

  • Page 1 Best wishes! Batteries (setup and care): Your TX16S Radio Transmitter is delivered with the LiPo battery unplugged for safety during transportation. Open the battery case and connect the LiPo battery to the Radio Transmitter. Close the battery case. Please fully charge the Radio Transmitter before first use.
  • Page 2 OriginHobbies_OMP_M1_M2_TX16S_RTF_OMP_v1.1 Radio Switch Assignment (OMPHobby mode): Switch position guide: ↑ (away from you), - (middle), ↓ (towards you) Throttle hold switch: SG (↑Armed, -Throttle cut, ↓Throttle cut) Flight mode switch: SE (↑Norm, -Idleup1, ↓Idleup2) Self level switch: SA (↑Self level ON, -Self level OFF, ↓Self level OFF) Flight timer reset switch: SH (↑Timer active, ↓Timer reset) Volume Control: S2 knob Flight timer: 3.5 mins, Haptic countdown at 10 seconds...
  • Page 3 OriginHobbies_OMP_M1_M2_TX16S_RTF_OMP_v1.1 7. Place the Helicopter on a level surface and plug in the battery to the Helicopter. Wait for gyro initialization to complete. It will indicate with beeps and twitching servos. 8. Move Aileron, Elevator and Collective Pitch sticks on Radio and check if servos are moving in right order and direction.