Table of Contents
Advertisement
SW-D8000U, 16CH. COLOR VIDEO MULTIPLEXER
This option in the MOTION DETECTION sub-menu is used to activate the indicator 'M' for motion
detection on Monitor-A. The factory default setting is set to activate the indicator. If you desire the
on-screen indicator not to display when motion is detected then select NO in the sub-menu. This is
a "global" setting and will affect all cameras with enabled motion detection. If motion has been
turned on, but there is no 'M' indication in the corresponding cameras display when motion is
present, check the SETUP ACTIVE ZONES and the sensitivity settings as detailed below.
ACTIVITY / INTRUSION
The SETUP PARAMETERS for motion detection (sensitivity, target size, false alarm rejection,
record rate, output relays and links to alarm inputs), are chosen on a camera-by-camera basis. The
parameters available for each camera in this menu item will depend on whether INTRUSION
DETECTION or ACTIVITY DETECTION is the intended use of that camera.
In the ACTIVITY/INTRUSION sub-menu you may select by camera number the intended use of
motion detection. (The factory default for each camera is ACTIVITY DETECTION.) This selection
will result in different SETUP PARAMETERS for either INTRUSION DETECTION or ACTIVITY
DETECTION.
SETUP PARAMETERS
Activity Parameters Setup
The menu for ACTIVITY PARAMETERS SETUP appears as:
Sensitivity:
The motion detection sensitivity on each camera can be set to levels of 1-10. This setting is set on
a camera-by-camera basis, and applies to all the ENABLED zones in any particular camera scene.
Each of the 256 zones (16 x 16 grid) stores 256 grey levels of discrimination, averaged over the
zone's area. Changes in the 256 grey levels in a zone can be set as follows:
q
1 = least sensitive setting = detect change of 100 of 256 grey levels in a zone, averaged
over a zone.
q
10 = most sensitive setting = detect change of 5 of 256 grey levels in a zone, averaged over
a zone.
NOTE:
The highest sensitivity of 10 is only reasonable if the video signal has extremely low
noise. (The factory default sensitivity setting is 5, for all cameras.)
Recommendations:
60
JVC PROFESSIONAL, IMAGING PRODUCTS
Activity Parameters Setup
Camera
:
Sensitivity
:
Record Rate
: 4X
Relay Output
: 02
[CANCEL]
[OK]
01
05
Advertisement
Table of Contents
