Table of Contents
Advertisement
Installation
:
Warning
Risk of electric shock/fire/
material damage/damage to
the appliance!
If the appliance is not installed
properly, this may lead to a
dangerous situation. Ensure
the following:
The mains voltage on your
■
power socket must match the
rated voltage specified on
the appliance (identification
plate). The connected loads
and the required fuse
protection are specified on
the identification plate.
The appliance must not be
■
supplied through an external
switching device, such as a
timer, or connected to a
circuit that is regularly
switched on and off by a
utility.
The mains plug and the
■
protective contact socket
must match and the earthing
system must be correctly
installed.
The installation must have an
■
adequate cross section.
The mains plug must be
■
freely accessible at all times.
If this is not possible, in order
to comply with the relevant
safety regulations, a switch
(all pole disconnection) must
be built into the permanent
installation in accordance
with electrical installation
regulations.
Safety instructions
If using a residual current
■
circuit breaker, only use one
that bears the following mark:
z. The presence of this
mark is the only way to be
sure that it fulfils all the
applicable regulations.
:
Warning
Risk of electric shock/fire/
material damage/damage to
the appliance!
If the appliance's mains cable is
altered or damaged, this may
result in electric shock, short
circuiting or fire due to
overheating.
The mains cable must not be
kinked, crushed or altered, and
must not come into contact with
any heat sources.
:
Warning
Risk of fire/material damage/
damage to the appliance!
The use of extension cords or
power strips may result in fire
due to overheating or short
circuiting.
Connect the appliance directly
to an earthed socket that has
been correctly installed. Do not
use extension cords, power
strips or multi-way couplers.
en
7
Advertisement
Table of Contents
