Specifications - Makita HM1317C Instruction Manual

ENGLISH (Original instructions)
1. Switch lever
2. Adjusting dial
3. Power-ON indicator lamp (green)
4. Service indicator lamp (red)
5. Set bolt

SPECIFICATIONS

Model
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for chiselling work in concrete, brick,
stone and asphalt as well as for driving and compacting
with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Electric Breaker safety warnings
Safety instructions for all operations
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
cutting accessory may contact hidden wiring or its
4
Explanation of general view
6. Nut
7. Side handle
8. Bit
9. Tool retainer
10. Tool holder
HM1317C
715 mm
17.0 kg
ENE045-1
Additional safety warnings
1. Wear a hard hat (safety helmet), safety glasses
ENF002-2
2. Be sure the bit is secured in place before
3. Under normal operation, the tool is designed to
GEA010-2
4. In cold weather or when the tool has not been
5. Always be sure you have a firm footing. Be sure
6. Hold the tool firmly with both hands.
7. Keep hands away from moving parts.
8. Do not leave the tool running. Operate the tool
9. Do not point the tool at any one in the area when
GEB239-1
10. Do not touch the bit, parts close to the bit, or
11. Some material contains chemicals which may be
12. Do not touch the power plug with wet hands.
13. Before operation, make sure that there is no
11. Bit with collar
12. Bit without collar
13. When the bit is inserted
14. When the bit is retained
HM1307C HM1317CB
730 - 1,450
15.3 kg 19.0 kg
/II
own cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
operation.
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
no one is below when using the tool in high
locations.
only when hand-held.
operating. The bit could fly out and injure
someone seriously.
workpiece immediately after operation; they may
be extremely hot and could burn your skin.
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
buried object such as electric pipe, water pipe or
HM1307CB
824 mm
17.3 kg