Table of Contents
Advertisement
Installation Guidelines
Warning notes
WARNING:
Read and follow the instructions and precautions
in this guide and all documents referenced in this guide when
installing this device. Always refer to the vehicle
manufacturer's service manual for proper installation and
wiring of any aftermarket devices, including this device. Failure
to do so may result in property damage and/or personal injury.
WARNING:
Park the vehicle on a level surface before
beginning any maintenance or installation. Block the wheels to
prevent the vehicle from moving. Never work under a vehicle
supported only by jacks as jacks can slip and fall over.
WARNING:
All wires that carry electrical current to the IVS
device must be fused. Failure to fuse the power, ground, and
ignition wires can lead to serious personal injury and/or
property damage. If any wires or cables containing fuses/fuse
boxes need to be cut or otherwise shortened, always be
certain to replace such fuses/fuse boxes or install new ones.
9
Cross-Domain Computing Solutions | 2022-01-27
© Robert Bosch GmbH 2021. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
WARNING:
Wire Protection: Take all necessary measures to
protect all wire runs through a metal surface with a grommet or
other device and all wire runs outside the vehicle cab with a
loom. Always protect against wire fatigue and harness
abrasion by properly attaching wires at closely spaced
intervals, while avoiding contact with sharp edges or doing
anything else that might result in exposed wires. All wires
should be secured with tie wraps at least every one foot (30
cm/300 mm) or less. Do not over-tighten any tie wraps.
WARNING:
The IVS device shall not be placed anywhere on
the windshield that could obscure the vision of the driver and
cause unsafe vehicle operation.
WARNING:
Do not pound on IVS device for any reason as this
could crack the vehicle's windshield.
WARNING:
All electrical work in the vehicle should be
performed by an experienced technician.
Advertisement
Table of Contents
