Index of Parts and Functions
Rear panel
6
7
8
9
10
1
1
2
2
3
3
4
4
5
5
6
7
8
9
10
SFP terminal
adaptor.
The SFP adaptor is optional purchased.
E. AUDIO SDI (OUT) terminal (BNC)
Output terminal for the SDI IN1 or SFP IN signal,
supports 12G/6G/3G/HD/SD.
E. AUDIO SDI (IN) terminals (BNC)
Input terminals for the SDI signals:
SDI IN1: 12G/6G/3G/HD/SD
SDI IN2/3/4: 3G/HD/SD
The SDI terminals accept also EMBEDDED AUDIO signals including
up to 16 audio channels with a sampling frequency of 48 kHz.
HDMI terminal
Input / Output terminal for HDMI signals.
Will not display or output HDCP protected contects.
ETHERNET
1000M high speed RJ45 ethernet port, for webserver IP external
control. (
page 17)
GPI terminal
Terminal for controlling the monitor by GPI remote. (
RS485 UMD terminal
Terminal for controlling the monitor by TSL UMD Tallyman system.
(
Page 17.)
DC-IN terminal
Connect with DC12V-17V 4-pin XLR power adapter.
(Pin 1: Negative, Pin 4: Positive)
Make sure the DC adaptor load matches with the power
consumption of the monitor.
AC-IN terminal
Connect the provided AC power cord to an AC outlet, support
AC 100-240V, 50/60Hz, with 250V fuse.
AC Switcher
Switch to OFF will cut o AC power completely.
Note for connections
•
Before making any connections, turn o all the equipment.
•
User a cord whose plugs correctly match the terminals on this
monitor and the equipment.
•
Plugs should be rmly inserted; poor connections could cause
noise.
•
When unplugging a cord, be sure to grasp its plug and pull it
out.
•
DO NOT connect the power cord until all connections are
complete.
•
Refer also to the user manual of each piece of equipment.
Page 16.)
7