Warning Messages - JVC DLA-G150CLU Operating Instructions Manual

Warning Messages

The following shows the warning messages that can be displayed on the screen. When a warning message is displayed, take
the corrective action described here.
Message Cause
• No device is connected to the
input terminal.
• The terminal is connected but no
signal is output from the
connected device.
P C 1
* The selected input mode (input
terminal) name is shown in the
N o I n p u t
first line of the massage.
• The frequency of the input video
signal is out of range.
• The selected input mode (input
terminal) name is shown in the
first line of the message.
P C 1
Frequency of input signal is out of range.
• Though the frequency of the input
video signal is within the
acceptable range, other items
such as resolution are out of the
projector's specifications.
P C 1
• The selected input mode (input
S i g n a l i s n o t s u p p o r t e d .
terminal) name is shown in the
first line of the message.
• When the FREEZE button is
pressed, this message appears
for a few seconds.
• When a button not acceptable is
pressed during freezing, this
message appears for a few
FREEZE
seconds to notify that the image is
being frozen.
• When the FREEZE button is
pressed for the video signals that
cannot be frozen (UXGA 60Hz,
SXGA 60Hz.), this message
appears for a few seconds to
notify that the image cannot be
FREEZE
frozen.
* To forcibly clear the message,
press the EXIT button.
All manuals and user guides at all-guides.com
Corrective action Page
• Connect a device to the selected 9, 11,
terminal. 24 ~ 29,
• Operate the connected device 33
and output a signal.
• Input the video signals whose 22, 23,
frequency is within the projector's 70
specifications.
• Input the video signals that 22, 23,
satisfies the projector's 70
specifications.
• To release freezing, press the 12, 37
FREEZE button on the remote
control.
• Freeze function does not work for 12, 37
the inputted video signals.
To use this function, input the
video signals that can be frozen.
67
Warning Messages
Message Cause
• When the DIGITAL ZOOM button
is pressed for the video signals
that cannot be zoomed (UXGA
60Hz, SXGA 60Hz.), this
message appears for a few
seconds to notify that the image
D.ZOOM
cannot be digitally zoomed.
* To forcibly clear the message,
press the EXIT button.
Displayed when the lamp control
setting is set to NORMAL MODE
• Appears every time the projector
is turned on after the lamp use
time has exceeded 900 hours and
until it reaches 1000 hours.
Lamp replacement
* The message is cleared by
EXIT
pressing any button.
Displayed when the lamp control
setting is set to NORMAL MODE
• When the lamp use time reaches
1000 hours, the word "Warning"
blinks on the screen.
Warning
* To cancel this message, press
Lamp replacement
the EXIT button.
EXIT
However, the same message will
appear every hour.
* If the power is turned off after the
lamp use time has exceeded
1000 hours, the power can not be
turned on again.
* When the lamp use time reaches
1010 hours, the projector is
forcibly turned off and can not be
turned back on again.
68
Corrective action Page
• Digital-zoom function does not 13, 37
work for the inputted video
signals.
To use the this function, input the
video signals that can be digitally
zoomed.
• Arrange for a new lamp (lamp 44, 46
unit) or replace the lamp early.
• Replace with a new lamp (lamp 44, 46
unit) and reset the lamp time.