Sharp Accu-Set SPC1010ODX Instruction Manual & Warranty

Thank you for your purchase of this quality clock. The utmost care has gone into the design and manufacture of your
clock. Please read these instructions and store them in a safe place for future reference.
FEATURES
1. LCD display
2. Wall mount
3. UP / 12/24 button
4. TIME SET button
5. CAL. SET button
6. Lithium battery
compartment
7. Battery compartment
8. DOWN / C/ F button
9. Table stand
10. TIME ZONE switch
11. RESET button
12. DST ON/OFF button
SETTING PROCEDURE FOR THE CLOCK
Before inserting the 2 ì AAî batteries into the battery compartment
Time Zone
1. Slide the
2. Press the DST button to turn on the DST function if your area does observe DST.
3. Once all above is completed, insert
compartment following the polarity as shown on the diagram inside the compartment ,
4. The clock will fast forward to the correct time.
Note: Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries, only batteries of the
same or equivalent type as those recommended are to be used. Do not mix new and old batteries.
OPTIONAL M ANUAL TIME SET FUNCTION
TIME SET
1. Press and hold the
ress the or
2. P UP DOWN
3.
Press the TIME SET
ress the or
4. P UP DOWN
5. Press the
TIME SET
OPTIONAL MANUAL CALENDAR SET FUNCTION
1. Press and hold the CAL. SET
ress the or
UP DOWN
2. P
3.
CAL. SET
Press the
ress the or
4. P UP DOWN
5.
Repeat the above steps for date and language, and press the
TEMPERATURE DISPLAY
The temperature displays indoor temperature. At anytime switch between Celsius or Fahrenheit by pressing
button.
12/24 HOUR DISPLAY
Press the 12/24 button to switch between 12 hour or 24 hour display mode.
DST FUNCTION
- If you live in an area that does observe DST, press the
adjust automatically each spring and fall to correct for the 1-hour time change.
- If you live in area that does not observe DST, such as Arizona, Hawaii, or parts of Indiana, you do not need to do any
setting.
REPLACING 3V LITHIUM BATTERY
The Accu-Set time memory is maintained by a lithium button cell battery, model CR2032. The expected life of this
battery is about 3 years. Be sure that the two AA/LR6 batteries in the clock are fresh. This battery is located in the
small battery compartment. Open the lithium battery compartment with a screwdriver and replace the CR2032 lithium
battery observing the polarity. Then, close the compartment.
SPC1010ODX Accu-Set Digital Wall Clock
Instruction Manual & Warranty
1
switch to the correct time zone.
2 x A / LR batteries preferably alkaline batteries into the battery
A
button, the hour digit will start flashing.
button to advance to the correct hour.
button again, the minute digit will start flashing.
button to advance to the correct minute.
button again to confirm the setting.
button, the year digit will start flashing.
button to advance to the correct year.
button again, the month digit will start flashing.
button to advance to the correct month.
6 (
CAL. SET
DST button to turn on the DST function. The clock will now
2 3 4 5 6 7 8
)
.
button again to confirm the setting.
9 1011 12
C/ F