Reloading The Laundry; Changing The Programme; Interrupting Or Ending The Programme; End Of The Programme - Bosch WVG30440TR Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Operating the appliance
en

Reloading the laundry

When the programme has started, the
laundry can be reloaded or taken out as
required.
Touch the Başlat/Beklet (Start/Reload)
button. The washer dryer checks
whether reloading is possible.
Notes
If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ is lit ~ Reloading is not possible.
To continue the programme, select
the Başlat/Beklet (Start/Reload)
button.
Do not open the door until the door
lock symbolÕ goes out.
Do not leave door open for
a prolonged period – water could
run out of the laundry.
The reloading function cannot be
activated during the drying phase.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select Başlat/Beklet (Start/Reload).
1.
Select another programme. If
2.
required, adjust the default settings
and/or select additional functions.
Select Başlat/Beklet (Start/Reload).
3.
The new programme starts from
the beginning.
30
Interrupting or ending the
programme
For washing programmes at high
temperature:
Touch Başlat/Beklet (Start/Reload)
1.
button.
To cool down laundry: select
2.
O Durulama (Rinse).
Touch Başlat/Beklet (Start/Reload)
3.
button.
For washing programmes at low
temperature:
Touch Başlat/Beklet (Start/Reload)
1.
button.
Select Sıkma/Boşaltma (Spin/Drain)
2.
0/[.
Touch Başlat/Beklet (Start/Reload)
3.
button.
For drying programmes:
Select Kurutma (Intensive Dry) 5 or
1.
Hassas kurutma (Gentle Dry) ‰.
Touch Š Kurutma (Dry) button, and
2.
set drying time to 20 minutes.
Touch Başlat/Beklet (Start/Reload)
3.
button.

End of the programme

End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
Başlat/Beklet (Start/Reload) button to
start the final drain/spin cycle.

Advertisement

Table of Contents
loading

Table of Contents