Installation/Settings Problems - Canon 8468B023 Manual

Installation/Settings Problems

Together with this section, see
Problems with the Wireless LAN Connection (LBP6030w)
Problems with the USB Connection
Problems via the Print Server
Problems with the Wireless LAN Connection (LBP6030w)
Remote UI is not displayed.
The (Wi-Fi) indicator lights if a connection has been established. Check whether it is lit, and whether IP addresses are
correct. Then try to start the Remote UI again.
Front Side
Viewing Network Settings
Are you using a proxy server? If you are using a proxy server, add the machine's IP address to the [Exceptions] list (addresses
that do not use the proxy server) in the Web browser's proxy settings dialog.
Is communication on your computer restricted by a firewall? If the Remote UI cannot be displayed because of incorrect
settings, use the
Restricting Communication by Using Firewalls
Initializing by Using the Wi-Fi Key
A connection to a network cannot be established.
Check whether the machine is properly installed and ready to connect to the network.
When the machine cannot connect to the wireless LAN
You are unsure of the IP address that was set.
Viewing Network Settings
When the machine cannot connect to the wireless LAN
Check the status of your computer
Have the settings of the computer and the wireless router been completed?
Are the cables of the wireless router (including the power cord and LAN cable) correctly plugged in?
Is the wireless router turned ON?
If the problem persists even after checking the above:
Check whether the machine is turned ON
The
If the machine is turned ON, turn it OFF, and then turn it back ON.
Check the installation site of the machine and the wireless router
Is the machine too far from the wireless router?
Are there any obstacles such as walls between the machine and the wireless router?
Are there any appliances such as microwave ovens or digital cordless phones that emit radio waves near the
machine?
Common Problems.
(Wi-Fi) key to initialize the system management settings.
Turn OFF all of the devices, and then turn them ON again.
Wait for a while, and try again to connect to the network.
(Power) indicator does not light if the machine is not turned ON.
0HWJ-03H