Table of Contents
Advertisement
A flashing NO symbol, wait until YES
■
and ¼ light up.
Do not open the door until both the
YES and the ¼ symbols are lit.
A flashing NO symbol, it is not
■
possible to add laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry.
To continue the programme, press
the Start/Reload A button. The
programme continues automatically.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press Start/Reload A.
1.
Select the other programme.
2.
Press Start/Reload A. The new
3.
programme starts from the
beginning.
Cancel the programme
Programmes at high temperatures:
Press Start/Reload A
1.
To cool the laundry: Select O Rinse.
2.
Press Start/Reload A.
3.
For programmes at low temperatures:
Press Start/Reload A.
1.
Select 0 Spin or [ Empty.
2.
Press Start/Reload A.
3.
Programme end during rinse
hold
– – – 0 appears on the display panel
and the Start/Reload button indicator
lamp flashes.
To end the programme, set the
programme selector to 0 Spin /
[ Empty or select a spin speed. Then
press the Start/Reload A button.
Operating the appliance
Programme end
End appears on the display panel and
the Start/Reload button indicator lamp
is off.
If the 9 symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.
en
21
Advertisement
Table of Contents
