Table of Contents
Advertisement
WARNING
© Copyright 2015 ABB. All rights reserved.
Safety
Safe operation and maintenance
Safety during start-up / commissioning and operation
The turbine casing insulation of the TPS44-F supplied by ABB Turbo
Systems is also burst protection.
Serious personal injuries or fatal accidents can occur, if the turbine
casing insulation of the TPS44-F supplied by ABB Turbo Systems is
removed. The burst protection is integrated into the turbine casing
insulation of the TPS44-F supplied by ABB Turbo Systems.
Separate burst protection is fitted to TPS44-F turbochargers without
insulation that have been ordered from ABB Turbo Systems.
Never operate TPS44-F turbochargers that have been supplied by
ABB Turbo Systems with insulation if this insulation from ABB Turbo
Systems is not in place.
Never operate turbochargers without burst protection. If the
insulation from ABB Turbo Systems is not in place, the separate
burst protection (57200) must be fitted before operation. (See View
of turbocharger showing part numbers [➙ 124].)
Before starting work, carry out visual inspection of working area.
Remove any obstacles and objects lying around.
Before start-up / commissioning, check all pipes from and to
turbocharger for damage and leaks.
Don't work in any way that could impair safety when working on
turbocharger.
After about every 12 hours of operation or at least once a day, inspect
turbocharger for visible damage and defects.
Immediately report any damage or changes in operational
performance to person responsible.
If damage is discovered, immediately shut down turbocharger and
secure it against inadvertent or unauthorized use.
When switching on auxiliary power sources (hydraulics, pneumatics,
electricity, water), keep an eye open for any hazards resulting from
supplying these power sources.
Safety during cleaning
It is possible that detergents or solvents will be used for cleaning. In this
case, the safety instructions of the Hazard due to operating materials and
supplies section in this chapter must always be observed.
Protect the floor against unintentional penetration of detergents or
solvents before starting cleaning operations.
Operation Manual / TPS44-F.. - TPS61-F..
2
2.6
Page 23
Advertisement
Table of Contents
