Alignment And Adjustments - Samsung WF365 Series Technical Information

ALIGNMENT AND ADJUSTMENTS

To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
GENERAL ERROR FUNCTION
Error Code
NO
(Diagnostic Code
Error Image)
1 nd
2 LO
3 nF
4 FL
5 LE
6 1E
7 OE
8 dc
9 E2
[BIGBANG]Technical_information-03207A-03_EN.indd 2
WARNING
Description
The water level fails to drop below
the Reset Water Level within 15
minutes.
Door fails to Unlock After 7 attempts.
When the filling Continues for
more than 40 minutes or there is no
change of water level for 6 minutes.
Door fails to lock after 7 attempts.
A water level lower than the Reset
water level is detected for 5 seconds
during the Wash/Rinse cycle.
Water Level Sensor Trouble. (When
the input signal from the water level
sensor is out of range, the unit will
send out beeping sounds and halts
the cycle.)
A fault is detected in the water level
sensor. Data (frequency) shows
the water level is at or above the
overflow water level. (When this
condition is detected, the machine
will automatically starts draining
water until the water level falls
below the reset water level)
Unbalance or cabinet bump is
detected during final spin, which
prevents the drum from spinning
over 150 rpm. (Never exceeds 150
RPM due to unbalanced load)
Jammed Key.(When key input
signals are coming out for more than
30 seconds, it is regarded as a jam.)
2
Corrective Action
Go to " Will Not Drain"
Troubleshooting Section.
Go to " Will Not Unlock"
Troubleshooting Section.
Go to " No Water Fill"
Troubleshooting Section.
Go to " Will Not Lock"
Troubleshooting Section.
Go to "No Water Fill" Troubleshooting
Section.
Go to "No Water Fill"
Troubleshooting Section
First check to see that all of water
valves are not stuck. If water valves
are OK, check water level.
Go to "Wet Clothes" Troubleshooting
Section.
Check all of keys. If A key is sensed
to be pressed, all keys will do not
respond.
2013-7-16 17:15:01