Table of Contents
Advertisement
2.1
Broadcom NetXtreme Ethernet Boot Agent
The Broadcom NetXtreme Ethernet Boot Agent provides hardware-based Ethernet card
configurations.
To start the Broadcom NetXtreme Ethernet Boot Agent and access the main screen:
1.
Turn on the system.
2.
During POST, press <Ctrl>+<S> when the following screen appears.
Broadcom NetXtreme Ethernet Boot Agent
Copyright (C) 2000-2013 Broadcom Corporation
All rights reserved.
Press Ctrl-S to enter Configuration Menu
From the Device List screen, use the up/down arrow key to select an Ethernet device
3.
to configure then press <Enter>.
Comprehensive Configuration Management v7.10.31
Copyright (C) 2000-2014 Broadcom Corporation
All rights reserved.
<03:00:00> BCM57840 - 00:E0:18:09:05:2C MBA:v7.10.33 CCM:v7.10.31
<03:00:01> BCM57840 - 00:E0:18:09:05:2E MBA:v7.10.33 CCM:v7.10.31
From the Main Menu, use the up/down arrow key to select an item and press <Enter>
4.
Comprehensive Configuration Management v7.10.31
Copyright (C) 2000-2014 Broadcom Corporation
All rights reserved.
Current Adapter:Primary, Bus=03 Device=00 Func=00, MAC=C8:60:00:22:86:B7
2-2
Select Device to Configure
Select Device to Configure
[Enter]:Enter Next Menu; [↑|↓]:Next Entry; [ESC]:Quit Menu
[Enter]:Enter ; [↑|↓]:Next Entry; [ESC]:Quit Menu
Device Hardware Configuration
MBA Configuration
iSCSI Boot Configuration
NIC Partition Configuration
Configure Device Hardware Parameters
[Enter]:Enter ; [↑|↓]:Next Entry; [ESC]:Quit Menu
Device List
Main Menu
Chapter 2: Boot Agent Configuration
Advertisement
Table of Contents
