Specifications - Makita M6501 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of the European Directive,
on Waste
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately and
returned to an environmentally compatible
recycling facility.
Intended use
The tool is intended for drilling in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Model M6500
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Model
Steel
Wood
-1
)
Overall length
Net weight
Safety class
with household
Electric and
noise level determined
) : 72 dB (A)
pA
END201-7
Model M6501
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration
waste
determined according to EN60745:
Model M6500
Electronic
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model M6501
Work mode: drilling into metal
ENE032-1
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
ENF002-2
measured in accordance with the standard test method
and may be used for comparing one tool with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
ENG905-1
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
2
M6500
6.5 mm
9 mm
4,500
200 mm
0.92 kg
/II
) : 70 dB (A)
pA
Wear ear protection
total value
) : 2.5 m/s
h,D
2
) : 3.0 m/s
h,D
2
M6501
0 - 4,500
203 mm
0.95 kg
ENG900-1
(tri-axial vector sum)
2
2
ENG901-1