Page 2
Windows is a U.S. registered trademark of Microsoft Corporation. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty.
Table of contents 1 Identifying installed drives 2 Handling drives 3 Improving hard drive performance Using Disk Defragmenter ... 3 Using Disk Cleanup ... 3 4 Replacing a hard drive 5 Using an optical drive Inserting an optical disc (CD or DVD) ... 8 Removing an optical disc (CD or DVD) ...
Identifying installed drives To view the drives installed on the computer, select Start > Computer. NOTE: Windows® includes the User Account Control feature to improve the security of your computer. You may be prompted for your permission or password for tasks such as installing applications, running utilities, or changing Windows settings.
Handling drives Drives are fragile computer components that must be handled with care. Refer to the following cautions before handling drives. Additional cautions are included with the procedures to which they apply. CAUTION: To reduce the risk of damage to the computer, damage to a drive, or loss of information, observe these precautions: Before you move a computer or external hard drive from one location, initiate Sleep, and allow the screen to clear.
Improving hard drive performance Using Disk Defragmenter As you use the computer, files on the hard drive become fragmented. Disk Defragmenter consolidates the fragmented files and folders on the hard drive so that the system can run more efficiently. To run Disk Defragmenter: Select Start >...
Replacing a hard drive CAUTION: To prevent information loss or an unresponsive system: Shut down the computer before removing the hard drive from the hard drive bay. Do not remove the hard drive while the computer is on, in the Sleep state, or in Hibernation. If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the power button.
Page 11
Pull the hard drive tab to the left (2) to disconnect the hard drive. Lift the hard drive (3) out of the hard drive bay. To install a hard drive: Insert the hard drive into the hard drive bay (1). Pull the hard drive tab (2) to the right until the hard drive snaps into place.
Page 12
Tighten the hard drive cover screws (3). Chapter 4 Replacing a hard drive...
Using an optical drive An optical drive, such as a DVD-ROM drive, supports optical discs (CDs and DVDs). These discs store or transport information and play music and movies. DVDs have a higher storage capacity than CDs. All optical drives can read from optical discs and some drives can also write to optical discs, as described in the following table.
Inserting an optical disc (CD or DVD) Turn on the computer. Press the release button (1) on the drive bezel to release the disc tray. Pull out the tray (2). Hold the disc by the edges to avoid touching the flat surfaces and position the disc label-side up over the tray spindle.
Removing an optical disc (CD or DVD) There are 2 ways to remove a disc, depending on whether the disc tray opens normally or not. When the disc tray opens Press the release button (1) on the drive bezel to release the disc tray, and then gently pull out the tray (2) until it stops.
Page 16
Remove the disc (3) from the tray by gently pressing down on the spindle while lifting the outer edges of the disc. Hold the disc by the edges and avoid touching the flat surfaces. NOTE: If the tray is not fully accessible, tilt the disc carefully as you remove it. Close the disc tray and place the disc in a protective case.
Using external drives Removable external drives expand your options for storing and accessing information. A USB drive can be added by connecting the drive to a USB port on the computer. USB drives include the following types: ● 1.44-megabyte diskette drive ●...
Using optional external devices NOTE: For more information about required software and drivers, or to learn which computer port to use, refer to the manufacturer's instructions. To connect an external device to the computer: CAUTION: To reduce the risk of damage to the equipment when connecting a powered device, be sure that the device is turned off and the AC power cord is unplugged.
Using an optional external MultiBay or external MultiBay II An external MultiBay or MultiBay II connects to a USB port on the computer and enables you to use MultiBay and MultiBay II devices. For more information about the external MultiBay, refer to the user guide that is included with the device. Using an optional external MultiBay or external MultiBay II...
Index airport security devices 2 inserting 8 removing 9 CD drive 7, 11 Disk Cleanup software 3 Disk Defragmenter software 3 disk performance 3 diskette drive 11 drives caring for 2 diskette 11 external 11 hard 4, 5, 11 MultiBay 13 optical 7, 11 See also hard drive;...