Related Manuals for Latham CS3000
Summary of Contents for Latham CS3000
- Page 1 CS3000 Automatic Safety Pool Cover Under Track System with Aluminum Lid INSTALLATION GUIDE...
- Page 2 Skill saw with carbide tipped blade 16. Drill (cordless or corded) 33. Pencil or marker Sawzall, Grinder, Angle drill 17. Set of drill bits (1/4” down to 1/16”) 34. 6 - 8 clamps © Latham Pool Products, Inc. 2019. All rights reserved.
- Page 3 The above parts list is typical for most pools up to 20’ x 40’ and includes all parts necessary to install the Coverstar system, however, parts will vary for longer or wider pools and according to your specific order. © Latham Pool Products, Inc. 2019. All rights reserved.
- Page 4 STANDARD UNDER TRACK Step By Step Instructions Page/Step Track assembly ..........5/1 Mounting the track Standard under track mounting ....5/6 Encapsulated under track mounting..5/7 © Latham Pool Products, Inc. 2019. All rights reserved.
- Page 5 Remove the installation. (See cover installation section page track that will extend into the housing. guide feed. Do this for the track on both 11, step 9). sides of the pool. © Latham Pool Products, Inc. 2019. All rights reserved.
-
Page 6: Table Of Contents
Adjusting the mechanism height ......7/4 Positioning the roll-up tube/mechanism ....7/7 Anchoring the mechanism ........8/12 Extending the pulley brackets ........8/13 Anchoring the pulley brackets ........8/17 Wiring the electrical switch ........9/19 Electrical wiring & bonding diagram .......9/24 © Latham Pool Products, Inc. 2019. All rights reserved. -
Page 7: Housing Preparation
Adjust height of the non-motor end feet if needed to level the roll-up tube. © Latham Pool Products, Inc. 2019. All rights reserved. -
Page 8: Anchoring The Mechanism
Raise the pulley bracket so nylock nuts (29) provided and bolt the cross places as possible. it is flush with the top of the encapsulation. braces together in two places on each cross bracket. © Latham Pool Products, Inc. 2019. All rights reserved. -
Page 9: Wiring The Electrical Switch
Motor draws 8.8 amps. from top of deck. Coverstar has several different wiring options that include limit switches wireless remote control, water feature shutoffs, etc. See your Coverstar distributor for details. © Latham Pool Products, Inc. 2019. All rights reserved. - Page 10 Running out the cover ...........14/30 Attaching the cover and bonding wire ....14/31 Mechanism adjustments (if needed only) Rope adjustment ...........14/34 Torque limiter adjustment ........15/37 Rope reel and non-motor end brake ....15/39 © Latham Pool Products, Inc. 2019. All rights reserved.
-
Page 11: Step By Step Instructions
1” into the housing. the rope into the end of the track. This is especially useful if encapsulation isn’t being used and the tracks are already installed. © Latham Pool Products, Inc. 2019. All rights reserved. -
Page 12: Routing The Ropes
Tighten completely using 10-32 leading edge tube. nylock (29), then back the nut off 1⁄2 turn. © Latham Pool Products, Inc. 2019. All rights reserved. -
Page 13: Track Retainer Method
In some cases you will only need to cut one rope. © Latham Pool Products, Inc. 2019. All rights reserved. -
Page 14: Running Out The Cover
Pull the excess that the cover needed to travel to close all the rope off the rope reel. way. While holding the rope, run the switch in the cover position. © Latham Pool Products, Inc. 2019. All rights reserved. -
Page 15: Torque Limiter Adjustment
7/16” adjust this brake, use two 7/16” wrenches wrenches or sockets to adjust the tension on and tightening or loosening the thru bolts in the rope reel. the brake block. © Latham Pool Products, Inc. 2019. All rights reserved. - Page 16 CLASSIC ALUMINUM LID Step By Step Instructions Page/Step Installing the lid brackets .......17/1 Assembling the aluminum lid ......17/4 Attaching the lid to the deck ......17/7 © Latham Pool Products, Inc. 2019. All rights reserved.
- Page 17 1/4” masonry bit. Remove installation is now complete. Now instruct concrete dust from the holes. the home owner using the home owner's guide and the checklist on the next page. © Latham Pool Products, Inc. 2019. All rights reserved.
- Page 18 Who is authorized to operate the cover system ....6 Pool chemicals and cover life ........8 Proper maintenance and care of the cover system ... 8-9 Inform the customer on pool safety ....Back cover © Latham Pool Products, Inc. 2019. All rights reserved.
- Page 19 © Latham Pool Products, Inc. 2019. All rights reserved.
- Page 20 QUESTIONS? For questions about this installation guide, contact your Independent Coverstar Distributor. Latham Pool Products 787 Watervleit-Shaker Rd. Latham, NY 12110 USA L9910 Updated 7.23.19 © Latham Pool Products, Inc. 2019. All rights reserved.