Table of Contents
Advertisement
Inserting and Removing Bits
and Drivers
1.
Set the direction switch, located just
above the trigger, so that it is in the
center locked position.
2.
Hold the chuck by the collar while
turning the sleeve (the forward sec-
tion). See Figure 3. This will cause
the three chuck jaws located inside
the recess to open or close depend-
ing upon the direction.
3.
When the jaws are at the approximate
diameter of the bit or driver, insert the
shank end of the bit or driver into the
jaw opening.
4.
Turn the sleeve clockwise until it tight-
ens around the bit or driver. Never
"power tighten" which is holding the
sleeve while running the drill. This
can cause a loose grip on the bit or
driver and potential damage to chuck
jaws. Check for tightness periodically
while using the tool.
5.
To release the bit or driver, hold the
chuck collar, and turn the sleeve
counterclockwise.
G9921 18V Cordless Set
DRILL OPERATION
Fig 3. Inserting bits into the chuck.
Operating this equipment has the
potential to propel debris into the air
which can cause eye injury. Always
wear safety glasses or goggles when
operating equipment. Be certain the
safety glasses you wear meet the
appropriate
standards
American
National
Institute (ANSI).
of
the
Standards
-8
-
Advertisement
Table of Contents
