Table of Contents
Advertisement
LV-WX310ST/LV-X310ST
For adjusting the size to your desired, you need to move the
product for appropriate projection distance. Follow the procedure
below for the installation and adjustment.
The focus will be off after adjusting the projection distance, so be
sure to readjust the focus. If the image is very blurry, adjusting the
focus to make the image sharp will change the size of the projected
image. Adjust the projection distance and focus repeatedly in
alternation as necessary.
1.
Adjust Focus. (using (C) Focus Ring)
2.
Move the product back and forth to adjust the screen size.
3.
Adjust Focus again if necessary.
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or
bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will
need to manually correct it following one of these steps.
•
Press
/
Keystone correction page. Press
top of the image. Press
the image. Press
image. Press
•
Using the OSD menu
1.
Press MENU and then press
highlighted.
2.
Press
to highlight Keystone and press OK/IMAGE. The
Keystone correction page is displayed.
3.
Press
to correct keystoning at the top of the image or press
to correct keystoning at the bottom of the image. Press
correct keystoning at the left side of the image. Press
keystoning at the right side of the image.
•
You can correct the vertical and horizontal keystones. However, their adjustment ranges are
limited in such correction.
•
When the keystone adjustment is carried out, the adjustment value is indicated. Note that this
value doesn't mean a projection angle.
•
The allowable range of the adjustment value in the keystone adjustment varies depending on
the installation conditions.
•
Images may not be projected in a shape of a regular rectangle or with its aspect ratio 4:3,
depending on the installation conditions of the projector and the screen.
•
When the keystone adjustment takes effect, the resolution decreases. In addition, stripes may
appear or straight lines may bend in images with complicated patterns. They are not due to
product malfunctions.
•
Noise may appear on the screen during the keystone adjustment because of the type of the
video signal being projected and the setting values of the keystone adjustment. In such cases,
set the keystone adjustment values in the range where the image is displayed without noise.
•
When the keystone adjustment is carried out, the image may not be displayed correctly
because of the type of input signal.
36
on the projector or remote control to display the
to correct keystoning at the bottom of
to correct keystoning at the left side of the
to correct keystoning at the right side of the image.
/
to correct keystoning at the
until the DISPLAY menu is
to
to correct
C
Press
Press
/ .
Press
Press
/
.
/ .
/
.
Advertisement
Table of Contents
