Table of Contents
Advertisement
The Connection/Power Menu
The Connection/Power menu is used for setting for the connections and power.
Items
Item descriptions
LAN Settings
IP Address
Auto (DHCP): The IP address is assigned automatically from the DHCP
*1
Setup
server such as a router.
Manual: To specify the IP Address manually.
WLAN Settings
WLAN
On/Off: Set the wireless output of the USB wireless LAN module (not
*2
Connection
supplied) to On/Off.
WLAN
Access Pt. (Auto)/Access Pt. (Manual)
*3
Network
WLAN.
Network
Presentation
Connection
On/Off: This is the presentation function via the network. It controls the
CODE
connection using the displayed number (CODE) on the right bottom of the
screen. During the image transmission, using the ENTER key on the remote
commander makes Connection CODE display again.
*6
HDBaseT setting
Sets the function of the HDBaseT/LAN terminal.
HDBaseT/
HDBaseT: Connecting the HDBaseT transmitter and the LAN cable
LAN
enables transmitting the signal of the Video, Audio, Ethernet, and
terminal
RS-232C.
LAN: Connecting the LAN cable for Ethernet directly enables connecting
to the network.
(Use when connecting the cable directly without the HDBaseT transmitter.)
RS-232C
Via HDBaseT: You can connect this unit to the RS-232C terminal via the
setting
HDBaseT transmitter. (Baud rate: 9600bps)
RS-232C terminal: Use when connecting to the RS-232C terminal of this
unit directly.
*7
Dynamic Range
Sets the image input level of the INPUT B/C/D terminal.
Auto: Distinguishes the image input level automatically.
Limited: Set when the image input level is 16-235.
Full: Set when the image input level is 0-255.
Input-A Signal Sel.
Auto/Computer/Video GBR/Component: When set to "Auto," selects the
type of video signal input automatically when "Input-A" is selected.
ECO
High/Standard/Low/Auto
Lamp Mode
brighter, and power consumption becomes higher. When set to "Low,"
power consumption is minimized; however, the image will be darker. When
set to "Auto," brightness is adjusted automatically according to image
content. Dark images are projected with brightness adjusted, leading to
energy-saving. Bright images are projected brightly, without adjusting
brightness.
Constant
On/Off: Available when the lamp mode is set to High. Outputs light at a
Brightness
certain brightness.
*4
*10 *11
: When set to "High," the image becomes
*12
*5
/Client
: Changes modes for
*8
The Connection/Power Menu
*9
31
Advertisement
Table of Contents
