AEG 47056IU-MN User Manual page 32

32 www.aeg.com
The appliance does not
operate
The appliance does not
operate
The appliance does not
operate
The appliance does not
operate
The appliance does not
operate
The oven does not heat
up
The oven lamp does not
operate
Steam and condensation
settle on the food and in
the oven cavity
The display shows
"12.00" and "LED"
The residual heat indica-
tors does not come on
The cooking zone re-
duces the heat setting to
A sound operates when
the appliance is off
Heat setting alternates
A sound operates and
appliance starts and
stops again. After 5 sec-
onds one more sound
operates
comes on
Problem Possible cause
The fuse in the fuse box
is released
You touched 2 or more
sensor fields at the same
time
There is water or fat
stains on the control
panel
The child safety device
or key lock or oper-
ates
The appliance is not
switched on
The necessary settings
are not set
The oven lamp is defec-
tive
You left the dish in the
oven for too long
A power cut
The cooking zone is not
hot because it operated
only for a short time
You covered one or
more sensor fields or
there is water or fat
stains on the control
panel.
You covered one or
more sensor fields
The Power management
is active
You covered
The automatic switch-off
operates
Remedy
Control the fuse. If the
fuse is released more
than one time, refer to a
qualified electrician.
Only touch one sensor
field
Clean the control panel
See the chapter "Oper-
ating the appliance".
Switch on the appliance
Control the settings
Replace the oven lamp
Do not leave the dishes
in the oven for longer
than 15-20 minutes after
the cooking process
ends
Reset the clock
If the cooking zone must
be hot, speak to the af-
ter sales service
Uncover the sensor
fields. Clean the control
panel
Uncover the sensor
fields.
See the section Power
management
Uncover the sensor field
Stop the appliance and
start it again