Advertisement
COMPONENT
Measure the resistance : Across two terminals
w i t h a n O h m - M e t e r o n h i g h e s t s c a l e .
HIGH-VOLTAGE
CAPACITOR
including
BLEEDER
Ohm-Meter
RESISTOR
Measure the resistance : Across two terminals
with an Ohm-Meter on R x 10,000 scale.
HIGH-VOLTAGE
DIODE
CHECKOUT PROCEDURE
Ohm-Meter
- 5 -
Normal reading :
Momentarily indicates several Ohms,
and gradually returns to 10 Meg-Ohms.
Abnormal reading :
Indicates continuity or 10 Meg-Ohms
from the beginning.
Figure 7
Normal reading :
Indicates about the middle position in
one direction (forward direction) and
infinite Ohms in the reverse direction,
using meter which is provided with a
9 volt battery.
--Some digital meter may show over
even in a forward direction because
low measuring voltage of meter does
not allow the meter current to pass
Figure 8
through the High Voltage Diode.
Abnormal reading :
Indicates continuity or infinite Ohms
in both directions.
RESULT
NOTE
Advertisement
