Remote Control Battery Installation; Remote Control Operating Range; Remote Control Code - Sanyo PLC-WXU700 Owner's Manual

Remote Control Battery Installation

Open the battery
1
compartment lid.
Press the lid
downward and slide it.
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Remote Control Operating Range

Point the remote control toward the projector when pressing
the buttons. Maximum operating range for the remote
control is about 16.4'(5 m) and 60 degrees in front of the
projector.

Remote Control Code

The eight different remote control codes (Code 1 – Code 8) are assigned to this projector. Switching the remote
control codes prevents interference from other remote controls when several projectors or video equipment
next to each other are operated at the same time. Change the remote control code for the projector first before
changing that for the remote control. See "Remote control" in the Setting Menu on page 58.
While pressing the MENU button, press the IMAGE
1
button number of times corresponding to the remote
control code. See the list below.
 To initialize the remote control code, slide the RESET/
ON/ALL-OFF switch to RESET, and then to ON. The
initial code is set to Code 1.
Remote Control Code
Code 1
Code 
Code 3
Code 4
Code 5
Code 6
Code 7
Code 8
Install new batteries

into the compartment.
Number of Times
Pressing IMAGE
Button
1

3
4
5
6
7
8
Part Names and Functions
3
Two AAA size batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins in
compartment.
Replace the
compartment lid.
16.4'
(5 m)
30°
30°
Remote control
While pressing the MENU
button, press the IMAGE
button number of times
corresponding to the remote
control code.
MENU button
IMAGE button
RESET/ON/ALL-
OFF switch
13