Problems And Solutions - Epson Stylus DX4250 Basic Operation Manual

Problems and Solutions

Check the solutions below if you are having trouble
using your EPSON STYLUS DX.
Copying Problems
■
Make sure your original is positioned in the top
left corner of the document table.
■
If the edges of the copy are cropped off, move the
original away from the corner slightly.
■
Make sure your paper is loaded short edge first,
all the way to the right, with the left edge guide
against its left side. Do not load paper above the
c arrow mark inside the left edge guide.
Paper Feeding Problems
■
Remove the paper from the sheet feeder. Flip
through the stack to separate the sheets. Then
reload the paper against the right edge, and slide
the left edge guide against the paper (but not too
tightly). Make sure the paper is not in front of the
feeder guard.
■
Do not load too many sheets at once. & Page 5 for
information about the number of sheets you can
load.
■
If paper is jammed, the b Error light flashes.
Follow these steps to clear the jam:
1. Press the x Start Color button to eject the jammed
paper. If the jammed paper is not ejected, go on to
the next step.
2. If the paper is stuck near the sheet feeder or output
tray, gently pull it out then press the x Start Color
button.
If the paper is stuck inside the EPSON STYLUS
DX, press the P On button to turn it off. Open the
scanner unit and remove any paper inside,
including any torn pieces. Do not pull it backward;
this can damage the sheet feeder. Close the
scanner unit, then turn the EPSON STYLUS DX
back on.
Print Quality Problems
If you have any problems with the copy or print
quality, try these solutions:
■
Make sure the document is placed flat against the
document table and the EPSON STYLUS DX is not
tilted or placed on an uneven surface.
■
Load the paper printable side up (usually the
whiter, brighter, or glossy side).
20
Solving Problems
■
Make sure your paper is not damp or curled.
■
Load your paper one sheet at a time. Remove
sheets from the output tray so not too many collect
at a time.
■
Make the paper size and paper type settings on the
control panel match the type of paper you loaded
(& Page 5).
■
For the best print quality, use Epson paper
(& Page 5) and genuine Epson ink cartridges
(& Page 14).
■
Set the paper thickness lever to the m position for
most paper types. If you are printing on
envelopes, set the lever to the ^ position.
■
If you notice light or dark bands across your
printouts or they are too faint, you may need to
clean the print head. Run a nozzle check as
described on Page 16 to see if the print head needs
cleaning.
■
Clean the print head as described on Page 16.
■
If you notice jagged vertical lines, you may need
to align the print head. & Page 17 for instructions.
■
The ink cartridges may be old or low on ink.
& Page 14 for instructions on replacing an ink
cartridge.
■
If a dotted line appears in the image, clean the
document table with a soft, dry, lint-free cloth
(paper towels are not recommended), or use a
small amount of glass cleaner on a soft cloth, if
necessary. Do not spray glass cleaner directly on
the document table.
Print Head Problem
If the ink cartridge cover does not close or the print
head does not move to its home position, open the
cover and push the ink cartridges down until they
click into place.
Other Problem
When you turn off your EPSON STYLUS DX, a red
lamp inside the EPSON STYLUS DX may remain on.
The lamp will stay on for a maximum of 15 minutes,
then go out automatically. This does not indicate
malfunction.