Zanussi ZWF8163BW User Manual page 12

STARTING A PROGRAMME WITHOUT THE
KLAAR OVER/FINI DANS OPTION
Touch the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks, the
indicator
• The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
STARTING A PROGRAMME WITH THE KLAAR
OVER/FINI DANS OPTION
1. Touch the button
choose the number of hours in which you want
the washing cycle to be finished.
The display shows the number of hours you set
(e.g. ) and the indicator above the button
on to show that his option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Klaar Over/Fini Dans option before
you touch the button
touching the button
cancel the Klaar Over/Fini Dans
option.
To cancel the the Klaar Over/Fini Dans option:
a. Touch the button
to pause. The indicator of button
flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
12
.
stops to
is on.
again and again to
:
. After
you can only
to set the appliance
until the indicator
again to start the
1. Touch
The indicator of this button flashes.
2. Change the options. If you change any option
the Klaar Over/Fini Dans option (if set) will be
disabled.
3. Touch
The programme continues.
CANCELLING A PROGRAMME
1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR
While a programme (or the
is
appliance door is locked. The indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
To open the door during the first minutes of
the cycle (or when the
1. Touch the button
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button
The programme (or the
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display
• The indicator of the button
• The door lock indicator
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Press the button
deactivate the appliance.
• Close the water tap.
.
again.
for some seconds to
) operates, the
operates) :
to pause the appliance.
goes off.
) continues.
comes on.
goes off.
goes off.
for some seconds to
is on.
again.