Advertisement
3 Release the lever and keep the plates together for 5 to 10 seconds.
4 Press the lever to open the plates and place the next section of hair
between the plates. Make sure there is an overlap.
5 Repeat this process until you have reached the hair tip.
6 To style the rest of your hair, repeat steps 2 to 5.
Create straight sleek style and flicks (Fig.9)
1 Make sure that the flat surfaces (
the lever (
between the straightening plates.
2 Slide down slowly the length of the hair in a single motion (max. 5
seconds) from root to end, without stopping to prevent overheating.
•
To create your desired type of flick, turn the styler half-circle
inwards (or outwards) when it reaches the last 3-5 cm of the hair
tip. Hold in that position for 2 to 3 seconds, and then release it.
3 To style the rest of your hair, repeat steps 1 to 2.
Note: The appliance is equipped with an auto-shut off function. After
60 minutes, the appliance switches off automatically. You can re-start
the appliance by sliding the ON/OFF switch to | to power on the styler
again.
After use:
1 Switch off the appliance and unplug it.
2 Place it on a heat-resistant surface until it cools down.
3 Remove hairs and dust from the appliance and attachments.
4 Clean the appliance and attachments by damp cloth.
5 Keep the appliance in a safe and dry place, free of dust. You can also
hang it with the hanging loop (
resistant pouch (
) to open the attachment and place a section of hair
).
) are facing each other. Press
) or store it in the supplied heat
Advertisement
