Table of Contents
Advertisement
SOUND
SOURCE
EFFECT
LEVEL
VOL
WOOFER
SOUNDBAR
SOUrCe
Press to select a source connected to the Soundbar.
* Bt Pairing mode
To turn on BT PaIrInG mode in Bluetooth function, press and hold the
SOUrCe button for more than 5 seconds.
Play / Pause (BT / WIfI)
Press the p button to pause a music temporarily.
Press the p button again to play the selected music.
LeVeL
The aTmoS Soundbar has 3.1.2 channel sound. Use this button to adjust
the volume of each of the speakers. Press this button, use the Left/right
buttons to select a speaker, and then use the Up/Down buttons to increase
or decrease the level (volume).
FTL
FL
Speaker
front Left
front Top Left
Center
front right
front Top right
* network Standby On/Off
Press and hold the LeVeL button for about 5 seconds to turn the network
Standby on or off. (See page 31)
(Sound Control)
Press to select treBLe, BaSS, or aUDiO SynC. Then, use the
Up/Down buttons to adjust the treBLe or BaSS volume from -3 ~ +3.
(Sound Control) button for about 5 seconds to
Press and hold the
adjust the sound for each frequency band. 150Hz, 300Hz, 600Hz, 1.2KHz,
2.5KHz, 5KHz, and 10KHz are selectable (Left/right) and each can be
adjusted to a setting between -6 ~ +6 (Up/Down).
If the Soundbar is connected to a digital TV and the video appears out of
sync with the audio, press the
with the video. Use the Up/Down buttons to set the audio delay between 0
ms ~ 300 ms. In BT mode, the audio Sync function may not available.
11
DESCRIPTIONS
FTR
C
Main Unit
Displayed on OLeD when
adjusting the level
fL
fTL
C
fr
fTr
(Sound Control) button to sync the audio
FR
Advertisement
Table of Contents
