NEC LS-D2462CL Owner's Manual page 9

About the remote control on the system
Strorage and Tips For Using the Remote Control
• The remote control may be stored inside the system
or mounted on a wall.
How to Insert the Batteries
Remove the battery cover by pulling
it according to the arrow direction.
Insert new batteries making sure that
the (+) and (-) of battery are installed
correctly.
Reattach the cover by pushing it
back into position.
Inside the Indoor System
Some controls are located inside the indoor unit. Open the front panel by lifting it up.
Slide Switch Operation (Refer to page 16)
FORCED OPERATION: Used for operation when the remote control cannot be used.
AUTO RESTART: In case the power comes on again after a power failure, the air
conditioner will operate in "Auto Restart Operation" mode. This function automatically
returns the air conditioner to the pervious operating conditions.
REMOTE CONTROL: If you do not want to use Auto Restart Operation
Signal Receptor
Receives the signals from the remote control.
(Signal receiving sound: two short beeps or one long beep.
Operation Indication Lamps
On/Off : Lights up during the system operation.
Sleep Mode : Lights up during Sleep Mode Auto operation.
Timer : Lights up during Timer operation.
Defrost Mode : Lights up during Defrost Mode or Hot Start operation
: Lights up during outdoor unit operation.
OUT OUTDOOR
UNIT
DOOR
OPERATION
NOTES:
• Use 2 AAA(1.5volt) batteries. Do not use
rechargeable batteries.
• Remove the batteries from the remote
control if the system is not going to be
used for a long time.
(Heat pump model only)
(Cooling model only)
• To operate the room air conditioner, aim the
remote control at the signal receptor.
• The remote control will operate the air
conditioner at a distance of up to 7m.
9
Signal
Receptor
Slide Switch
Operation indication lamps
Signal receptor