ENGLISH (Original instructions) SPECIFICATIONS Model: DJS200 Max. cutting capacities * Steel up to 400 N/mm 2.0 mm (14 ga) Stainless Steel up to 600 N/mm 1.6 mm (16 ga) Strokes per minute 0 - 3,000 min Overall length 345 mm Rated voltage D.C.
WARNING: WARNING: DO NOT let comfort or famil- The vibration emission during actual use of the power tool can differ from the declared val- iarity with product (gained from repeated ue(s) depending on the ways in which the tool is used use) replace strict adherence to safety especially what kind of workpiece is processed.
► Fig.1: 1. Red indicator 2. Button 3. Battery cartridge 18. Keep the battery away from children. SAVE THESE INSTRUCTIONS. CAUTION: Always install the battery cartridge fully until the red indicator cannot be seen. If not, CAUTION: Only use genuine Makita batteries. it may accidentally fall out of the tool, causing injury to Use of non-genuine Makita batteries, or batteries that you or someone around you. have been altered, may result in the battery bursting causing fires, personal injury and damage. It will CAUTION:...
Page 7
Lighting the lamp NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. CAUTION: Do not look in the light or see the NOTE: The first (far left) indicator lamp will blink when source of light directly. the battery protection system works. To turn on the lamp, slightly pull the switch trigger, and Tool / battery protection system then release it. The lamp goes out approximately 10 seconds after releasing the switch trigger. ► Fig.4: 1.
Loosen bolts with the hex wrench (5/32"). Move the CAUTION: These accessories or attachments side blade L back and forth to adjust it. Then tighten the are recommended for use with your Makita tool three bolts with the hex wrench (5/32"). specified in this manual. The use of any other ► Fig.10: 1. Bolt 2. Side blade L accessories or attachments might present a risk of Lubrication injury to persons. Only use accessory or attachment...