Table of Contents
Advertisement
ERROR MESSAGES
Below is an explanation of error messages. Refer to these when necessary (if you press
while the error message is displayed, the message disappears).
Error messages
Attach the embroidery frame.
1
Cannot change the configuration of the characters.
2
Cannot embroider since the embroidery unit is not
3
attached. Turn off the machine, and then attach the
embroidery unit.
Cannot recognize the data for the selected pattern.
4
The data may be corrupted.
Change to a larger embroidery frame.
5
Check and rethread the upper thread.
6
Failed to save file.
7
Includes a special pattern that cannot be saved to
external memory. Save the pattern in the machine's
8
memory.
Lower the presser foot lever.
9
Make sure embroidery frame is moved as far back
10
as possible. LOCK DOWN THE FRAME-SECURING
LEVER.
No more patterns can be added to this
11
combination.
Not enough available memory to save the data.
12
Delete some patterns or use a different media.
Not enough available memory to save the pattern.
13
Delete another pattern?
OK to cancel the current pattern selection?
14
15
OK to delete the selected picture?
OK to move the embroidery carriage to its previous
16
position?
OK to recall and resume previous memory?
17
OK to revert to previous color changes?
18
Cause/solution
This message is displayed when the machine is ready to embroider pattern,
and the "Start/Stop" button is pushed while the embroidery frame is not
attached.
This message is displayed when there are too many characters and the
curved character configuration is impossible.
This message is displayed when the "Start/Stop" button is pushed and the
machine is in embroidery mode, but the embroidery unit is not attached.
This message is displayed when there is a possibility that the data for the
selected pattern is corrupted.
This message is displayed when the machine is in embroidery mode and the
small frame is attached, and the selected pattern does not fit in the small
frame.
This message is displayed when the upper thread is broken or not threaded
correctly, and the "Start/Stop" button is pressed.
This message appears when you try to save more than 100 settings screen
image files in the USB media. In this case, delete a file from the USB media
or use different USB media.
This message is displayed when you try to save a copyright protected
pattern to USB media.
According to copyright laws, patterns that are illegal to reproduce or edit
cannot be saved to USB media. If this message displays, save the pattern in
the machine's memory.
This message is displayed when
while the presser foot lever is raised/the needle is lowered.
This message is displayed when the embroidery frame is attached.
This message is displayed when you try to cannot combine patterns.
This message is displayed when the memory is full and the embroidery
pattern cannot be saved.
This message is displayed when the memory is full and the embroidery
pattern cannot be saved.
This message is displayed when, after selecting a pattern,
and the pattern is about to be deleted.
This message is displayed when the image is deleted.
This message is displayed when replacing the embroidering bobbin thread.
This message appears if the machine is turned off while embroidering, then
turned on again. Press
to return the machine to the condition (pattern
position and number of stitches) when it was turned off. Follow the
procedure described in "If the Thread Breaks or the Bobbin Runs out of
Thread During Embroidering" on page 66 to align the needle position and
embroider the remainder of the pattern.
This message is displayed when
colors.
ERROR MESSAGES
or do the operation correctly
(Presser foot lifter button) is pushed
is pressed
is pressed when changing thread
5
113
Advertisement
Table of Contents
