Error Codes - Canon EOS 250D Advanced User's Manual

Error Codes

( 2 )
Number
Communications between the camera and lens is faulty. Clean the
lens contacts.
01
Clean the electrical contacts on the camera and lens, use a Canon lens,
or remove and install the battery again.
Card cannot be accessed. Reinsert/change card or format card with
the camera.
02
Remove and insert the card again, replace the card, or format the card.
Cannot save images because card is full. Replace card.
04
Replace the card, erase unnecessary images, or format the card.
Sensor cleaning could not be performed. Turn the camera off and
on again.
06
Operate the power switch.
An error prevented shooting. Turn the camera off and on again or
07, 10
20, 30 re-install the battery.
40, 50
60, 70
Use the power switch, reinsert the battery pack, or use a Canon lens.
80
* If the error message still appears after following the above instructions, write
down the error code number and contact your nearest Canon Service Center.
If there is a problem with the camera, an
( 1 )
error message will appear. Follow the on-
screen instructions.
(1) Error number
(2) Cause and countermeasures
Error Message and Solution
477