Making Connections - LG 22LB4500-TC Owner's Manual

16
ASSEMBLING AND PREPARING / MAKING CONNECTIONS
CAUTION
y Disconnect the power first, and then
move or install the TV. Otherwise electric
shock may occur.
y If you install the TV on a ceiling or slanted
wall, it may fall and result in severe injury.
Use an authorized LG wall mount and
contact the local dealer or qualified
personnel.
y Do not over tighten the screws as this
may cause damage to the TV and void
your warranty.
y Any damages or injuries by misuse or
using an improper accessory are not
covered by the manufacturer's warranty.
y Screw length from outer surface of back
cover should be under 8mm.
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
: M4 x L10
NOTE
y The wall mount kit includes an installation
manual and necessary parts.
y The wall mount bracket is not provided.
You can obtain additional accessories
from your local dealer.
y The length of screws may differ
depending on the wall mount. Make sure
to use the proper length.
y For more information, refer to the manual
supplied with the wall mount.

MAKING CONNECTIONS

This section on MAKING CONNECTIONS
mainly uses diagrams for the LB4500 models.
Connect various external devices to the TV
and switch input modes to select an external
device. For more information of external device's
connection, refer to the manual provided with
each device.
Available external devices are: HD receivers,
DVD players, VCRs, audio systems, USB
storage devices, PC, gaming devices, and other
external devices.
Back Cover
Max.8mm
NOTE
y The external device connection may differ
from the model.
y Connect external devices to the TV
regardless of the order of the TV port.
y If you record a TV programme on a
DVD recorder or VCR, make sure to
connect the TV signal input cable to the
TV through a DVD recorder or VCR. For
more information of recording, refer to
the manual provided with the connected
device.
y Refer to the external equipment's manual
for operating instructions.
y If you connect a gaming device to the TV,
use the cable supplied with the gaming
device.
y In PC mode, there may be noise
associated with the resolution, vertical
pattern, contrast or brightness. If noise is
present, change the PC output to another
resolution, change the refresh rate to
another rate or adjust the brightness and
contrast on the PICTURE menu until the
picture is clear.
y In PC mode, some resolution settings
may not work properly depending on the
graphics card.